concreting tower meaning in Chinese
混凝土浇灌塔
混凝土浇筑塔
混凝土升运塔
Examples
- Referring the application of prestressed concrete tower drum in practice , this paper primarily focuses on a few problems mentioned below and the author hopes to offer some contribution to the revision of the new norm
本文结合预应力混凝土塔筒在工程实际中的应用，主要针对以下几个问题进行了研究，希望对新规范的修编起到一定的作用。 - Secondly , according to the change of calculation formula when prestress were added to the chapter of concrete tower drum , the paper has given the calculation formulas of prestressed concrete tower drum in limited states of carrying capacity and normal serviceability
其次，针对高耸规范混凝土塔筒一章中增加预应力后，塔筒计算公式发生的变化，本文对预应力混凝土塔筒在承载能力极限状态和正常使用极限状态下的计算公式进行推导。 - Finally , with the research results , the author analyzes the two tv tower drums : the normal concrete tower and the presrtressed concrete tower . at the same time , the calculation reliability of prestressed concrete tower drum and dropping - coefficient of stiffness established in this paper has been proved
最后，利用本论文的研究成果，对普通混凝土电视塔和预应力电视塔进行实例分析，验证了本文建立的塔筒计算公式和刚度降低系数计算公式的可靠性。 - Since the current national standard , ( ( the standard of high - rising structure design ) } ( gbj135 - 90 ) , was established at the end of 1980 ' s according to the past engineering experience , it can not meet with the demand for the high - rising structure design . especially there are no articles which deal with the design of prestress technology in the chapter of concrete tower drum
由于我国现行的国家标准《高耸结构设计规范》 ( gbjl35 - 90 )是在20世纪80年代末根据以前的工程实践经验制定而成的，远远满足不了当前高耸结构设计中的需要，特别是在混凝土塔筒一章中还没有预应力技术设计的条文规定。 - Thirdly , for the sake of convenience for calculating the section stiffness of prestressed concrete tower drum , this paper interprets the relationship between the stiffness dropping - coefficient of prestressed concrete tower drum cross and prestress degree . based on the cross stiffness coefficient under different prestress , a brief method for calculating the stiffness dropping - coefficient is presented in this paper
第三，为了便于预应力混凝土塔筒截面刚度的计算，本文对塔筒截面刚度降低系数与截面预应力度的关系进行了研究，并根据不同预应力度下的截面刚度降低系数，归纳总结出一种简单的刚度降低系数计算方法。